Mower Deck Removal And Installation - Briggs & Stratton Legacy XL Operator's Manual

540 Rear PTO Operation (if equipped)
See Attachment Operator's Manual to properly install/
connect the attachment to be used. If connecting to
a stationary attachment, set the parking brake during
attachment operation.
Connecting a Drive Shaft
1. Disengage the PTO, set the parking brake, stop the
engine, and wait for all moving parts to stop.
2. Pull back on the locking collar (A, Figure 17) of the drive
shaft, and slide the socket on the PTO as far as it will go.
3. Pull back on the drive shaft until the locking collar snaps
into place. Check that the connection is secure.
A
Figure 17
Starting the PTO
1. Start the tractor engine. Allow the engine to warm-up for
several minutes before engaging the PTO.
2. Set engine throttle to FULL.
3. Place the PTO lever in the rear position (A, Figure 18) if
only a rear attachment is being used. If a mid and rear
attachment are being used simultaneously, place the lever
in the mid position (B). If only a mid or front attachment is
being used, place the lever in forward position (C).
4. Pull UP on the PTO switch to engage the PTO.
Note: ROPS roll bar is not shown for PTO lever position clarity.
A
B
Figure 18
22
C
Stopping the PTO
1. Move throttle control to IDLE and push the PTO switch
DOWN to disengage.
2. Stop the engine, remove the key, and set the parking
brake. Wait for all moving parts to stop.
3. Disconnecting a drive shaft, pull back on the locking
collar, and slide the drive shaft off the PTO.
540 Attachment Recommendations
This rear PTO box is designed to output a maximum of 18
horsepower at 540 RPM. Therefore it should only be used
to run 540 RPM attachments that require 18 HP or less.
Using this PTO box to run attachments that require more than
18 HP or an input shaft speed other than 540 could result in
poor performance, shortened equipment life, or equipment
damage, and will void the tractor warranty. Improper use can
also create an unsafe condition resulting in injury.
Start-up and Stopping Loads
This PTO can be used with direct drive attachments that have
small start-up and stopping loads like tillers or mower decks.
DO NOT use this PTO box with attachments that require a large
amount of torque to start, such as direct drive chipper/shredders
and large silo blowers, which may damage the PTO clutch.
Large attachments that have their own clutching
mechanism to lessen the load on the PTO box during
starting and stopping may be used provided they do not
exceed the 18 horsepower limit.
Overload Protection
Any attachment used with this PTO box MUST have shear
pin(s), shear bolt(s), a slip clutch, or some other device to
prevent PTO box damage if the attachment should jam.
Attaching a Trailer
The maximum trailer weight should be less than 800 lbs
(363 kg). Secure the trailer with an appropriately sized
clevis pin (A, Figure 19) and clip (B).
A
B
3'4"
(1m)
Figure 19
Excessive trailer loads can cause loss of traction and loss
of control on slopes. Reduce trailer weight when operating
on slopes. The surface being driven on greatly impacts
traction and stability. Wet or slippery surfaces can greatly
reduce traction and the ability to stop or turn.
Mower Deck Removal
and Installation
See Mower Deck Manual for removal and installation
instructions.
10˚
20' (6m)