SAFETY INSTRUCTIONS • Read the manual carefully before use and keep it for future reference. • Do not use in humid environments such as saunas and bathrooms. • Do not use if the room temperature is above 40 ° C. •...
CONTROLS DISPLAY 1. Speed + 2. Speed - 3. START / STOP 4. Time + 5. Time - 6. Turn on / off 7. Function 8. Mode The preset value for the training time is 10 min divided into 10 segments. Use the Time + / - buttons to adjust the time.
REMOTE CONTROLLER 1. If the device is plugged in, press to turn on the device, press again to turn it off. 2. Auto mode: Press to select a preset function. + 3D oscillation + blood circulation support +3D swing +3D blood circulation support + linear 3,4.
RUBBER EXPANDERS To use rubber expanders, expanders must be attached to the device. For proper attachment, make a loop at the end of the expander and pass it through the holder under the device. There is one expander handle on each side of the device. Once you thread the eye through the handle, pull the handle through the eye.
Stand on the platform, keep your feet shoulder wide. Grip the expanders. Slowly turn the torso to the right and left. Stay for a few seconds on each side, then return to the center. Exercise can also be done with expanders and stretched arms in front of you.
Put the palms on the platform in the shoulder width. Legs stretch. Keep your back straight and your abdominal muscles clenched. Lift the chest from the platform. The exercise strengthens the muscles of the chest, shoulders and triceps. If the exercise is too difficult, kneel down. Put the palms on the platform in the shoulder width.
MAINTENANCE AND STORAGE Make sure the product is turned off and unplugged before maintenance. Clean rubber surfaces with a damp soft cloth and warm water. For more durable dirt, you can use non- aggressive cleaners. Do not use thinners, aggressive cleaners, solvents, etc. Only use the dry cloth to wipe the controller.
TERMS AND CONDITIONS OF WARRANTY, WARRANTY CLAIMS General Conditions of Warranty and Definition of Terms All Warranty Conditions stated hereunder determine Warranty Coverage and Warranty Claim Procedure. Conditions of Warranty and Warranty Claims are governed by Act No. 89/2012 Coll. Civil Code, and Act No.
Page 13
If the Buyer gives notice of a defect that is not covered by the Warranty (e.g. in the case that the Warranty Conditions were not fulfilled or in the case of reporting the defect by mistake etc.), the Seller is eligible to require a compensation for all the costs arising from the repair. The cost shall be calculated according to the valid price list of services and transport costs.
Need help?
Do you have a question about the Julisa and is the answer not in the manual?
Questions and answers