Table of Contents
Advertisement
Unpacking
The Creator was carefully hand-packed by the staff at the FlashForge factory.
Please follow the unpacking steps laid out below and heed all warnings.
! Handle with extra special care. Do not use any unnecessary force.
! Do not remove the thin yellow film from the heating plate. It is a heat-resistant
adhesive tape intended to improve the adhesion of the materials to the plate.
! Do not remove the wrapping around the nozzle. It consists of ceramic fiber fabric
and heat-resistant adhesive tape which helps the temperature remain constant in the
heating zone and the filament is yielded uniformly.
First, put the box on the floor in a clean and flat work area. Remove the top carton,
and then pull out the cardboard packing material that encases the Creator.
第 四 页 共 四 页
Advertisement
Table of Contents
Need help?
Do you have a question about the Creator and is the answer not in the manual?
Questions and answers