Figure 43 40G QSFP+/100G QSFP28 copper cable
1
(1) Connector
NOTE:
• As a best practice, use H3C transceiver modules and cables for the QSFP28 ports on the switch.
H3C transceiver modules and cables available for the QSFP28 ports are subject to change over
time. For the most up-to-date list of H3C transceiver modules and cables available for the
QSFP28 ports, contact H3C Support or marketing staff.
• For more information about H3C transceiver modules and cables, see H3C Transceiver Modules
User Guide.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Table 23 System status LED description
LED mark
SYS
QSFP28 port LED
Table 24 QSFP28 port LED description
LED status
Steady green
Flashing green
Steady yellow
2
Status
Steady green
Flashing green
Steady red
Flashing red
Off
Description
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 100 Gbps.
The port is sending or receiving data at 100 Gbps.
A transceiver module or cable has been correctly installed. The port has a link and
is operating at 40 Gbps.
(2) Pull latch
Description
The switch is operating correctly.
The switch is performing power-on self test (POST).
The system has failed POST, or a problem has occurred.
Some ports have failed POST or failed to operate.
The switch is powered off or has failed to start up.
43