Electrolux EOB7S31V User Manual page 42

42 www.electrolux.com
4. Put 250 ml of the descaling agent in
the water drawer.
5. Fill the remaining part of the water
drawer with water to the maximum
level until the acoustic signal sounds
or the display shows the message.
The duration of the procedure is
about 1 hour 40 minutes.
6. Activate Descaling function - S3.
Refer to "Activating a cleaning
function".
7. After the end of the first part, empty
the tray and put it on the first shelf
position again.
8. Activate the Rinsing function. Refer
to "Steam generation system -
Rinsing - S4".
Remove the tray after the end of the
procedure.
If the function Descaling is
not performed in the correct
way, the display will show a
message to repeat it.
If the appliance is humid and wet, wipe it
out with a dry cloth. Let the appliance dry
fully with the door open.
12.10 Descaling reminder
There are two descaling reminders which
remind you to perform the function:
Descaling. These reminders activate
each time you switch off the appliance.
When reminder is active S3 flashes in
the display.
• The soft reminder reminds and
recommends you to perform the
descaling cycle.
• The hard reminder obligates you to
perform the descaling. If you do not
descale the appliance when the hard
reminder is on, you cannot use the
steam functions. You cannot disable
the descaling reminder.
12.11 Steam generation system
- Rinsing - S4
Remove all accessories.
The duration of the function is around 30
minutes.
The light in this function is off.
1. Put the tray on the first shelf position.
2. Fill the water drawer with fresh water
to the maximum level until the
acoustic signal sounds or the display
shows the message.
3. Activate Rinsing function - S4. Refer
to "Activating a cleaning function".
Remove the tray after the end of the
procedure.
12.12 Removing and installing
the door
You can remove the door and the
internal glass panels to clean it. The
number of glass panels is different for
different models.
WARNING!
The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A)
on the two door hinges.
A
3. Close the oven door to the first
opening position (approximately 70°
angle).
4. Hold the door with one hand on each
side and pull it away from the oven at
an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
6. Hold the door trim (B) on the top
edge of the door at the two sides and
push inwards to release the clip seal.
2
B
7. Pull the door trim to the front to
remove it.
A
1