Table of Contents
Advertisement
Appendix A Racks
Secure the rack in one of the following ways:
Note that because all rack-securing methods will require some construction work, a
specialist will need to be consulted.
Securing the rack with bolt stabilizers
Affix bolt stabilizers (*1) to the front and back and sides of the rack and anchor the
stabilizers to the building structure (floor).
*1:
The bolt stabilizers comprise an optional product. The following kit needs to
be purchased:
Earthquake proofing kit: MC-R1ST11 (Kit for the Fujitsu 19-inch global/
basic rack.)
MC-R1ST21 (Kit for the Fujitsu 19-inch global/expansion rack.)
Note that the pull-out stabilizer supplied as standard is not required if the
earthquake proofing kit (MC-R1ST11) is to be used. Note also that the
standard pull-out stabilizer and the earthquake proofing kit (MC-R1ST11)
cannot be used jointly. In cases where the pull-out stabilizer is not used,
store it in a safe place in case the racks are moved in the feature.
Left bolt stabilizer (*1)
Bolted to floor
Securing the rack with leveling feet
Use the threaded holes at the bottom of the rack leveling feet to anchor the leveling
feet to the building structure (floor) (See
are already built into the rack structure can be anchored with M20 bolts.
Note:
The pull-out stabilizer supplied as standard is not required if the rack is
secured with leveling feet. However, in consideration of the possibility that
the racks will be moved in the future, Fujitsu recommends jointly using the
standard pull-out stabilizers. In cases where the pull-out stabilizer is not
used, store it in a safe place in case the racks are moved in the feature.
A-4
Front bolt stabilizer
Figure A.2 Securing the rack with bolt stabilizers
Rear bolt stabilizer
Right bolt stabilizer (*1)
Figure
A.3). The rack leveling feet that
U41644-J-Z816-5-76
Advertisement
Table of Contents
