Advertisement
Skid Plate Installation:
C
STEP 5: Install the (2) M10x30 bolts (C), lock washers (D) and flat washers (E)
through the holes at the rear of the skid pate and thread them into the cross brace.
Snug but do not fully tighten with a 17mm socket. Next, loosely tighten the rear
bolts of the engine skid plate with a 17mm and 19mm socket.
STEP 6: Make sure that all the skid plates align to your liking and then fully tighten
all the fasteners. Using a torque wrench tighten all M10 bolts to 36 ft lbs and all
M12/factory fasteners to 48 ft lbs.
D
E
A
The Trusted Source
6
®
Advertisement
