Casio QG-100 Operation, Service Manual & Parts List page 24

• Tape Cutting
Possible Cause
Tape cutter is worn.
• Label Adhesion
Possible Cause
Backing paper is not removed.
Attempt to stick label onto improper object or
surface.
• Communications
Possible Cause
Improper cable connections.
• Data Communications
Digital camera error display, no response from QG-100 keys, cannot display digital camera images.
Possible Cause
Improper cable connections.
• During Operation
Possible Cause
Dead digital camera batteries.
If you continue to have problems after performing the recommended actions described above, consult
with your original dealer.
* REMARK
Refer to 23 ~24 pages on
Tape does not cut.
Label does not stick.
Cannot transfer data.
Image disappears from digital camera monitor screen.
and .
5
3
— 22 —
Recommended Action
Consult with your original dealer.
Recommended Action
Remove the backing paper from the label to ex-
pose its adhesive.
Labels will not stick to surfaces that are rough,
wet, oily, or dirty.
Recommended Action
1.Turn off digital camera and QG-100 power in
the sequence under
5
2.Press in SB-62 cable plugs as far as they will
go.
3.Turn on digital camera and QG-100 power in
the sequence under
3
Recommended Action
1.Turn off QG-100 power.
2.Turn off digital camera power.
3.Turn on digital camera and QG-100 power in
the sequence under
3
Recommended Action
Turn off QG-100 power and then replace digital
camera batteries.
*.
*.
*.