Cabling A Single-Interconnect Configuration; Hardware Management Network Connectivity - Lenovo ThinkAgile CP Series Hardware Installation Manual

Cabling a single-interconnect configuration

Procedures for cabling theThinkAgile CP single-interconnect switch configuration.
Complete these procedures to cable a single-interconnect configuration.
Hardware management network connections
Connect the following ports to the management switch:
• Interconnect port 47 using a SFP+ Direct Attach Cable (DAC)
• Compute block port (C.M.) using a RJ45 patch cable
• Upper storage block port (S.U.M.) using a RJ45 patch cable
• Lower storage block port (S.L.M.) using a RJ45 patch cable
Figure 28. Hardware management network connectivity in a single interconnect configuration
Note: If not using the Lenovo ThinkSystem NE0152T RackSwitch as the management switch, you may
require different cables for the management network connections.
. 47
Chapter 3 ThinkAgile CP Setup