Installing The Rail In A Round Hole Rack - Lenovo ThinkAgile CP Series Hardware Installation Manual

Hide thumbs Also See for ThinkAgile CP Series:
Table of Contents

Advertisement

Install the storage slide rails into a round hole rack
Procedures for installing ThinkAgile CP storage block slide rails in a round hole rack.
To install the ThinkAgile CP storage block slide rails in a round hole rack, do the following:
Attention: Ensure that you install the rear mounting rail brackets before installing the front mounting
brackets.
Figure 10. Installing the rail in a round hole rack
Step 1.
Open the hinge bracket on the rear of the rail.
Step 2.
Line up the pins on the rear of the rail with the corresponding holes in the rear-mounting flange of
the rack, and then insert the pins into the holes in the rack flange.
Step 3.
Close the hinge bracket to secure the rail to the rack flange.
Step 4.
Secure the rear mounting bracket of the rail with two M5 screws.
.
Chapter 3
ThinkAgile CP Setup
25

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkagile cp6000Thinkagile cp4000

Table of Contents