Installing The Rail In A Square Hole Rack - Lenovo ThinkAgile CP Series Hardware Installation Manual

Hide thumbs Also See for ThinkAgile CP Series:
Table of Contents

Advertisement

Install the storage slide rails into a square hole rack
Procedures for installing ThinkAgile CP storage block slide rails in a square hole rack.
To install the ThinkAgile CP storage block slide rails in a square hole rack, do the following:
Attention: Ensure that you install the rear mounting rail brackets before installing the front mounting
brackets.
Figure 11. Installing the rail in a square hole rack
Step 1.
Open the hinge bracket on the rear of the rail.
Step 2.
Remove the preinstalled screw pins for round hole rack.
Step 3.
Line up the holes on the rear of the rail with the corresponding holes in the rear-mounting flange of
the rack.
Step 4.
Close the hinge bracket to secure the rail to the rack flange.
Step 5.
Secure the rear mounting bracket of the rail with two screws for square hole rack.
.
Chapter 3
ThinkAgile CP Setup
27

Advertisement

Table of Contents
loading

This manual is also suitable for:

Thinkagile cp6000Thinkagile cp4000

Table of Contents