Victron energy MultiPlus 12/3000/120 – 50 Manual page 39

Extremely powerful sine inverter, battery charger and automatic switch in a compact casing
Table of Contents

Advertisement

Step 2: Exemplary setting for parallel mode
In this example, the master is configured according to factory settings.
The slaves do not require setting!
Master
DS-8 Ch. voltage(GEL 14,4V)
DS-7 Ch. voltage(GEL 14,4V) on
DS-6 Absorption time (8 h)
DS-5 Adaptive charging (on)
DS-4 Dyn. current limit (off)
DS-3 UPS function (on)
DS-2 Voltage (120V)
DS-1 Frequency (60Hz)
To store the settings after the required values have been set: press the 'Down' button
of the master for 2 seconds (lower button to the right of the DIP switches). The
temperature and low-battery LED's will flash to indicate acceptance of the
settings.
You can then leave the DIP switches in the selected positions, so that the 'other
settings' can always be recovered.
To start the system: first, turn all devices off. The system will start up as soon
as all devices have been turned on.
Slave 1
off
DS-8 na
DS-7 na
on
DS-6 na
on
DS-5 na
off
DS-4 na
on
DS-3 na
on
DS-2 na
off
DS-1 na
Slave 2
DS-8 na
DS-7 na
DS-6 na
DS-5 na
DS-4 na
DS-3 na
DS-2 na
DS-1 na
35

Advertisement

Table of Contents
loading

This manual is also suitable for:

Multiplus 24/3000/70 – 50

Table of Contents