System Synchronization Cable - Thermo Scientific Surveyor LC Pump Plus Hardware Manual

System Synchronization Cable

Thermo Scientific
The Surveyor System Accessory Kit (P/N SRVYR-SYSKT) contains two system
synchronization (contact closure) cables. One cable has five combicon connectors, and the
other cable has seven combicon connectors.
System synchronization cable
F5049-010
M/S
M/S
 To connect the cable with five combicon connectors to the Surveyor system
1. To connect the Surveyor LC Pump Plus, plug the connector with the blue sticker labeled
LC PUMP into the eight-pin socket on the pump's back panel (see
2. To connect the Surveyor Autosampler Plus, plug the connector attached to the cable
labeled AS into the eight-pin socket labeled 1 through 8 on the autosampler's back panel.
3. To connect a Surveyor detector, plug the connector attached to the cable labeled DET
into the eight-pin socket labeled 1 through 8 on the detector's back panel.
 To connect the cable with seven combicon connectors to the Surveyor system
1. To connect the Surveyor LC Pump Plus, plug one of the connectors labeled PUMP into
the eight-pin socket on the pump's back panel (see
2. To connect the Surveyor Autosampler Plus, plug the connector attached to the cable
labeled AS into the eight-pin socket labeled 1 through 8 on the autosampler's back panel.
3. To connect a Surveyor detector, plug the connector labeled DET into the eight-pin socket
labeled 1 through 8 on the detector's back panel.
For information about making the contact closure connection between a Thermo Scientific
mass spectrometer and a Surveyor Plus LC system, refer to the Surveyor Plus Getting Connected
Guide.
DET
A/S
A/S
Connecting the Back Panel Cables
Part number
F5049-010
60053-63034
Figure 15
Figure 15 on page 20).
Surveyor LC Pump Plus Hardware Manual
2
Installation
on page 20).
21