Serial Communication Cable; System Interconnect Cable - Thermo Scientific Surveyor MS Pump Hardware Manual

2
Installation
Making the Initial Back Panel Connections

Serial Communication Cable

System Interconnect Cable

Connecting the 5-Connector Interconnect Cable to the LC Devices
Figure 8. 5-connector interconnect cable, P/N F5049-010
To
MS detector
12 Surveyor MS Pump and Surveyor MS Pump Plus Hardware Manual
The serial communication cable is a standard RS232 cable, approximately 2 meters long and
terminated at each end with a DB-9 pin connector. The serial communication cable is in the
accessory kit.
 To install the serial communication cable
1. Connect one end of the serial communication cable to an available serial port on the host
computer.
2. Connect the other end of the cable to the connector found on the back of the Surveyor
MS Pump Plus (see Figure
The interconnect cable coordinates the timing of the Surveyor Plus modules during an
injection sequence.
The Surveyor Plus LC devices are shipped with two versions of the interconnect cable: a
5-connector version (F5049-010) and a 7-connector version (60053-63034).
This topic contains the following procedures:
• Connecting the 5-Connector Interconnect Cable to the LC Devices
• Connecting the 7-Connector Interconnect Cable to the LC Devices
The 5-combicon connectors of the interconnect cable (P/N F5049-010) are labeled LC
PUMP, MS PUMP, A/S, DET, and M/S. See
M/S
To
Autosampler
To
MS pump
7).
Figure 8.
F5049-010
A/S
To
DET
detector
To
LC pump
Thermo Scientific