Explanation Of Parameters - Siemens SIMATIC ET 200SP Manual

Oversampling (OVS) operating mode
5.2 Parameters/address space
5.2.3

Explanation of parameters

Operating mode
At the module level, specifies the operating mode in which the module's channels are
operated.
● DI (Page 15) / Oversampling
● Counting (Page 31)
When configuring with HSP0229 for STEP 7, the operating mode is specified by selecting
the module name.
Sampling rate
Specifies the number of subcycles per isochronous data cycle.
Diagnostics: No supply voltage L+
Enabling of the diagnostics for no or insufficient supply voltage L+.
Diagnostics: Short-circuit to ground
Enabling of the diagnostics if a short-circuit of the actuator supply to ground occurs.
Channel activated
Determines whether a channel is enabled or disabled. If a digital input is disabled, the
module ignores its signals.
Input delay
This parameter can be used to avoid signal faults. Changes to the signal are only detected if
they are constantly pending longer than the set input delay time.
Isochronous configuration is only possible if there is no input delay configured for at least
one channel. In isochronous mode, the terminal signal is read in at the time T
reading the input data). The read time T
was configured.
For input channels with longer input delays, the read time is moved accordingly. This means
individual channels can be assigned input delays, if necessary, without having a negative
impact on the possible cycle time.
Note
If you select the "None" or "0.05 ms" option for the input delay, you have to use shielded
cables for connection of the digital inputs.
Potential group
Specifies whether a light-colored BaseUnit with incoming supply voltage is located on this
slot (see ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/58649293) system manual).
60
refers to the channel for which no input delay time
i
Digital input module DI 8x24VDC HS (6ES7131-6BF00-0DA0)
Equipment Manual, 11/2019, A5E35243810-AD
(time for
i