Steam Outlet; Getting Hot Water; Machine Stop; Dual Pressure Gauge (Where Expected) - Bezzera Galatea Domus Instruction Manual

2) Put the ground coffee into the filter holder,
press it and make attention that the filter hold-
er edge is not dirty with coffee.
3) Replace the filter holder in its housing.
4) Lift up the lever (Fig. 05) to obtain coffee dis-
pensing
5) To stop dispensing, when the desidered dose
is reached, take the lever back to downward
position, to allow the unloading of the group
and the drying of the coffee.
Caution:
- Do not remove the filter holder filled with cof-
fee when the equipment is operating.
- Do not touch expressly the metal plating of the
filter holder; danger of burns.
- The standard doses for the filters are 6/8
grams for a dose and 12 grams for two dos-
es.

5.4 Steam Outlet

(Fig. 06)
1) In order to avoid eddies in the boiler, let off
steam by turning the relevant knob
2) Insert the nozzle (Fig. 01; pos. 8) into the con-
tainer with the liquid to be heated.
3) Turn the steam knob (Fig. 01; pos. 9).
The outlet steam depends on the knob turning:
the more the knob is turned, the more the steam
is let off.
4) After the steam has been blown off, turn the
knob off, take out the container and clean
immediately the nozzle with a damp cloth in
order to remove residual heated water.

5.5 Getting Hot Water

1) Place the water container under the dispenser
(Fig. 01; pos.3).
2) Turn on the knob (Fig. 01; pos. 10) to get the
required quantity of water.

5.6 Machine Stop

1) Turn the main switch on position 0 (Fig. 01;
pos. 1).
2) Turn off the intercepting water tap (R version).
5.7 Dual pressure gauge
The machine is equipped with dual pressure
gauge by which you can check the following pres-
sures:
Boiler manometer (Fig. 01, pos. 14)
range 0~3 bar (0~3 MPa)
The boiler manometer indicates the boiler pres-
sure.
Pressure gauge (Fig. 01; pos. 15)
range 0~15 bar (0~1,5 MPa)
The pressure gauge indicates the pump maximum
pressure during operation. When the motor pump
is stopped the manometer indicates the water sup-
ply pressure (R version) or "0" (S version).

6 - MAINTENANCE

To allow the proper machine's operation, follow
the maintenance instructions indicated below.

6.1 Safety rules

Do not subject the machine to a water jet.
Disconnect the machine from the power line,
bringing the lever of the omnipolar switch of the
electric system in idle position "0" and close the
water shut-off valve prior to perform maintenance
and/or cleaning operations.
In case of failure of the machine, avoid any type
of repair without assistance and immediately con-
sult the technical assistance service.
In case the feeder cord is damaged, immediately
switch off the machine, close the water and con-
tact the technical assistance service. Avoid substi-
tuting it without assistance.
Perform cleaning/maintenance operations when
the machine is cold, preferably wearing protective
gloves for hands.

6.2 Cleaning of machine

These advices are indicative, the maintenance
and cleaning schedules depend on the use of the
machine.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and the filters.
Daily
1) Clean the cup holding grid and the drain ba-
23
GALATEA DOMUS
MOD.
(where expected)