Connect parking brake wire
1
Refer to the illustration below to connect
parking brake wire.
Mount in the dashboard
Note
•
Check wire connection before you mount the
unit into a car.
•
If preset radio stations are lost when the
ignition key is turned OFF and then back ON,
reconnect the red leads crosswise to the
yellow ones.
1
If the car does not have an on-board
drive or navigation computer, disconnect
the negative terminal of the car battery.
•
If you disconnect the car battery in
a car that has an on-board drive or
navigation computer, the computer
may lost its memory.
•
If the car battery is not disconnected,
to avoid short-circuit, ensure that
bare wires do not touch each other.
2
Ensure that car dashboard opening is
within these measurements:
Green/White
•
Since the unit cannot be used if the
dashboard opening's slant angle is
above 20 degrees: Ensure that the
horizontal slant of the car dashboard
opening is between 0 and 20 degrees
EN
15