Philips CED750/51 User Manual page 12

8 Red cable
9 White
cable
10 Red cable
11 white cable Rear line out R
Connect wires: without ISO
connectors
Caution
•
Ensure that all loose leads are insulated with
electrical tape.
1
Cut off the bigger end of the supplied
standard connector.
2
Check the car's wiring carefully, then
connect them to the standard connector.
0
9
8
7
Front line out L
Front line out R
Rear line out L
1
2
3
4
5
6
Connector Connect to
1 Blue/white The electric antenna
wire control lead or power
supply lead of the antenna
booster
If there is no electric
antenna or antenna booster,
or it is manually operated
telescopic antenna, it is not
necessary to connect this
lead.
2 Pink wire Reverse driving (see
'Connect reverse driving
cable' on page 14 )
3 Yellow wire The +12V car battery
which is live at all times.
4 Blue wire Amp. remote
5 Black wire A metal surface of the car
First connect the black
ground (earth) lead, then
connect the yellow and red
power supply leads.
6 Red wire The +12V power terminal
which is live in the
accessory (ACC) position
of the ignition switch
If there is no accessory
position, connect to the
+12V car battery terminal
that is always live. Be sure
to connect the black ground
(earth) lead to a metal
surface of the car fi rst.
7 Green and Left speaker (Rear)
green/black
wires
8 White and Left speaker (Front)
white/black
wires
9 Gray and Right speaker (Front)
gray/black
wires
Purple and Right speaker (Rear)
purple/black
wires
EN 13