Table of Contents
Advertisement
8
White and
Left speaker (Front)
white/black
wires
9
Gray and
Right speaker (Front)
gray/black
wires
0
Purple and
Right speaker (Rear)
purple/black
wires
2
Connect the other end of the two ISO
connectors to the car audio system.
3
If necessary, do the other connections.
Connect GPS antenna
To receive signal from satelite, you need to connect
the supplied GPS antenna to your car and the
system.
1
Connect the supplier GPS antenna to the
system first.
2
Stick the other end of the GPS antenna to a
metal surface of the car.
Connect radio antenna
If your car has built-in radio antenna, connect it to
the radio antenna of the system for better radio
signal.
1
Connect the radio antenna to the car
antenna.
Mount in the dashboard
Note
•
Check wire connection before you mount
the unit into a car.
If preset radio stations are lost when the
•
ignition key is turned OFF and then back
ON, reconnect the red leads crosswise to
the yellow ones.
b
c
2
3
4
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car battery.
•
If you disconnect the car battery in a car
that has an on-board drive or navigation
computer, the computer may lost its
memory.
•
If the car battery is not disconnected,
to avoid short-circuit, ensure that bare
wires do not touch each other.
2
Ensure that car dashboard opening is within
these measurements:
•
Since the unit cannot be used if the
dashboard opening's slant angle is above
20 degrees: Ensure that the horizontal
slant of the car dashboard opening is
between 0 and 20 degrees.
3
Slide the unit into the dashboard until a click
b
sound is heard.
4
Attach the trim plate.
5
Reconnect the negative terminal of the car
battery.
Turn on
Caution
•
Risk of road accidents! Never watch video or
adjust settings while you drive.
1
Press
to turn on the unit.
»
The available OSD (On-Screen Display)
languages are displayed.
a
Advertisement
Table of Contents
