Advertisement
English
Overview of parts 1
These are the supplied parts needed to connect
and install this unit.
a Main unit
b Sleeve
c Front panel
d Trim plate
e Rubber cushion
f Disassembly tools
g Screws (4 pieces)
h Standard ISO connector
Select country/region
1
Press
to turn on the unit.
2
Rotate
to select an option:
•
[USA] (United States)
•
[Latin] (Latin America)
•
[Europe] (Western Europe)
•
[ASIA] (Asia Pacific)
•
[Mid-East ] (Middle East)
•
[Russia] (Russia)
3
Press
to confirm.
Connection
For cars with ISO connectors
1
Pull out the ISO connectors from car
dashboard and connect them to the bigger
end of the supplied standard connector.
2
Connect the other end of the supplied
standard connector to the unit.
3
Connect the antenna and amplifier as
illustrated, if applicable. You can connect the
car audio to the amplifier through RCA-TO-
RCA cables (not supplied).
Connector
1 ANTENNA
2 REAR LINE
OUT R
2 34
Connect to
Antenna
Rear right speaker
3 REAR LINE
OUT L
For cars without ISO connectors
1
Connect the antenna and amplifier as
illustrated, if applicable.
2
Cut off the bigger end of the supplied
standard connector.
3
Check the car's wiring carefully, then connect
them to the supplied standard connector.
1
Green/black strip
2
White/black strip
3
Gray/black strip
4
Purple/black strip
e
RED
f
BLUE
g
BLACK
h
YELLOW
4
Connect the supplied standard connector to
the unit.
Mount into the dashboard 6
1
If the car does not have an on-board drive or
navigation computer, disconnect the negative
terminal of the car battery.
2
Remove the two screws on the top of the
unit.
3
Remove the mounting sleeve with the
supplied disassembly tools.
4
Install the sleeve into the dashboard and bend
the tabs outward to fix the sleeve.
Rear left speaker
4 5
Left speaker (Rear)
Left speaker
(Front)
Right speaker
(Front)
Right speaker
(Rear)
Ignition key +12V DC when
ON/ACC
Motor/electric antenna relay
control lead/Amplifier relay
control lead
Ground
To the +12V car battery
which is energized at all times
Advertisement
