Running The Code|Lab* Debugger; Launching And Configuring The Debugger; Manually Loading And Executing An Application Program - Intel IQ80315 Board Manual

B.7

Running the Code|Lab* Debugger

This section is provided to get the system up and running in the Code|Lab* Debug environment,
but it is not intended as a fully-functional tutorial. Refer to the ATI* Code|Lab Debug Reference
Manual for more detailed information.
B.7.1

Launching and Configuring the Debugger

1. In EDE, click on the icon that looks like a red bug. The "Connect" window appears.
2. When not configured from
perform steps 2–5.
3. Press Connect to enter debug mode.
a. The Code|Lab Debug environment appears with the Assembly window open.
Note: Mouseovers are available for most of the toolbar icons. (Leave the mouse over the debug icons
across the top on the toolbar to see a brief explanation of each.)
4. Click on the go icon and let RedBoot boot (takes a minute) until the RedBoot prompt
"RedBoot>" appears in the Console window (click the Console tab at the bottom of the Debug
window to view the Console window).
5. From the console window:
a. Type "diag".
b. Press "Enter".
The RedBoot Diagnostic function is invoked.
Try out a few of the tests as desired.
6. Close the Debugger and EDE environment.
7. Reset the board (cycle power).
B.7.2

Manually Loading and Executing an Application Program

1. Launch the Code|Lab Debug Environment from the desktop icon.
2. Ensure "File.../Program Load Options/Load Executable and Symbols" is checked.
3. Select menu File, Program Load Options, Load Executable and Symbols.
a. Select "File, Open Program, Browse".
b. Browse to find c:\...\Test80315\O\Test80315.elf.
4. Click "Go" (80, 03, 31, and 15 cycle on the LEDs).
5. Cycle power on the board.
®
Intel IQ80315 I/O Processor Evaluation Platform Board Manual
®
Intel IQ80315 I/O Processor Evaluation Platform
Section B.4.2, "Using Flash Programmer", go to Section B.4.2 and
61