Using Flash Programmer - Intel IQ80315 Board Manual

B.4.2

Using Flash Programmer

Note: The parallel port must be set to ECP mode or the Macraigor MPDemon will not work
Refer to the MPDemon manual to check the setting for the connection type selected. This example
assumes a parallel connection with the MPDemon. ECP mode must be the selection for the parallel
port.
Download the RedBoot executable files as follows:
1. Go to the following URL:
http://developer.intel.com/design/intelxscale/dev_tools/021022/index.htm
2. Scroll down to find and download Redboot Debug Monitor for the Intel® IQ80331 board.
After downloading:
1. Double click on the "Code|Lab Debug" icon on the desktop. The Connection Window appears.
2. Select "Macraigor JTAG Connection".
3. Click "Setup".
4. Select "MPDemon Parallel" (note the other connection options).
5. Do not check "Script Options" or "Enable Hot Debug".
6. Click "Configure".
7. Select "Parallel Connection" and "LPT1".
8. OCD Speeds must be "2" in both cases.
Note: The IQ80315 works only with speeds 2 through 7. Speed 1 and speed 8 do not work.
9. Click "OK".
10. Select "XScale 80200 (80315)".
11. Click "Additional Options".
12. Do not check "Enable Option" under "Scan Chain Options".
13. Do not check "Enable Option" under "Console Options". Instead, open HyperTerminal* (or
some equivalent serial terminal program). Select COM1 or COM2 as appropriate.
Baud Rate: 115200
Data Bits: 8
Parity: None
Stop Bits: 1
14. Then, back in Code|Lab, press OK, OK, OK (this returns to the Connect window).
15. Now press "Connect".
Assembly code is now visible.
16. Select "Memory/Flash..."
The OCDemon Flash Memory Programmer window appears.
17. The Flash programmer needs a file which is architecture-specific, in this case. In the Flash
programmer window, select "File/Open", then choose the file "Xscale TBD.ocd", located at
C:\MGC\Embedded\codelab\codelab Debug\Macraigor\.
®
Intel IQ80315 I/O Processor Evaluation Platform Board Manual
®
Intel IQ80315 I/O Processor Evaluation Platform
properly.
59