Advertisement
Options and settings specific to high-speed digitizers
For specific acquisition modes, you may need to use high-speed digitizer specific
settings. These settings are available throught the digitizer hadware extension, and
can be managed from: Input > Extensions.
Calibration equalization: This feature is not supported with M9703B digitizer.
ControlIO1 signal: The digitizer supports multi-purposes IOs. This option allows
to select the signal used for the ControlIO1. For details about the possible sig-
nals, please refer to the User manual of your digitizer, section Multi-Purpose
Inputs and Outputs.
Enable external clock: See
Enable interleaving: See
Error on overrange: This feature is not supported with M9703B digitizer.
External clock frequency: See
Force Software DDC: This option is effective only if your product has been
ordered with the -DDC option (Digital Down-Conversion). By default, this mode
is disabled, meaning that the downconversion is done by the hardware (in the
digitizer FPGA). When enabling Force Software DDC, you disable the DDC
mode of the digitizer and only use the software DDC from 89600 VSA. This can
allow you to visualize the difference and see the efficiency of the hardware
DDC.
M9703B Hardware Extension of 89600 VSA Software
External Clock (page 12)
Interleaved Mode (page 11)
External Clock (page 12)
89600 VSA Software Configuration
9
Advertisement
