Multi-Module Measurements
Then the multi-module mode should be enabled from the menu bar > Input window>
Extensions tab. Then select the Multiboard synchronization option. This operation is
only required a the master (instrument 1).
e. Define the channels to acquire. Menu path select Input > Channel > Custom.
Use the Channel Configuration GUI to reconfigure the channel mapping from
the physical hardware input ports to the VSA measurement channel inputs
(See picture below).
f. The multi-module synchronization will be effective after the next calibration.
20
By default, only the channel of the first digitizer (master) is
mapped in output. hus you have to add all the slave(s) channels
you want to analyze.
M9703B Hardware Extension of 89600 VSA Software