Keysight M9703B Configuration And Measurement Instructions page 14

High-speed digitizers hardware extension of keysight 89600 vsa software

Hide thumbs Also See for M9703B:

Measurement Setup Parameters

This section provides measurement and parameter setup information which are

specific to the 89600 VSA software when used along with the M9703B High Speed

Digitizer. This information can help you to properly setup the VSA in this hardware

configuration to make measurements using your digitizer.

Measurement Setup Parameters:

Alignment / Calibration

Channels

Connection

Coupling

Center Frequency Range Span

Frequency Counter

Hardware

Overlap

Alignment/Calibration: Whenever the digitizer configuration is changed, an internal

calibration is required if this new configuration has not yet been calibrated in the

current session. A manual calibration can be performed at any time from the menu

Utilities > Calibration.

Preset

Range

Recording

Setup Save/Recall

Trigger Holdoff

Triggering

The 89600 VSA software uses asynchronous polling to check the

calibration status of connected instruments. A

message may appear after a configuration change. This message

disappears after performing a new calibration.

If a signal is present on the input of the digitizer, it may affect the

internal calibration. If the input signal is preventing a successful

internal calibration, a pop-up warning message is raised. In such a

case, please perform a manual calibration with the signal turned

off or disconnected to allow a successful internal calibration .

CAL: Needed

M9703B Hardware Extension of 89600 VSA Software

Table of Contents