Status Leds - High End Systems Studio Command Series User Manual

CHAPTER 6
Troubleshooting

Status LEDs

™
Studio Command fixtures have five
Status LEDs on the display panel. The
status LEDs help analyze problems with
the Studio Command fixture
.
LED State
solid green
Motor
OFF
Lamp solid yellow
(700 model)
OFF
Lamp solid yellow
(H model)
OFF
solid red
5V
OFF
solid yellow
OFF
Transmit
flashing
solid or
(flickering green)
Receive
OFF
1
If you shut down the lamp using a remote shutdown command, the lamp and the Lamp LED will
shut off normally. However, if you have bad data cables, no data cables/controller connected to
the fixture, or the controller is off, the lamp and its LED will also be off. If correcting these prob-
lems does not turn the lamp on, see the next section.
2
Neither the Transmit nor the Receive LED will be on until you have connected the fixture to a
DMX 512-compatible controller using XLR data-grade cabling. If these LEDs remain OFF even
though you have connected the fixture to a controller and are sending DMX 512 commands to
the fixture, see the next section.
68
Status
LEDs
Problem
Indication?
No The motor power supply is receiving adequate voltage.
Yes Fuse or power failure.
Lamp power is on.
Lamp is striking.
No
The lamp power supply is receiving the proper voltage,
and the lamp is on.
1
Sometimes The lamp is extinguished.
No Lamp circuit is closed
Lamp circuit is open
No The logic board is receiving the required voltage.
Yes Fuse or power failure.
Fixture is crossloading software to other fixtures on the
No
link.
2
Sometimes DMX 512 data is not being transmitted.
The fixture is in preset playback mode, and is the
No master fixture or the fixture is a slave fixture receiving
an upload.
No The fixture is receiving data.
2
Sometimes DMX 512 data is not being received.
Description
Studio Command Series User Manual