Control Parameter; Studio Command 1200/700; Studio Command H - High End Systems Studio Command Series User Manual

Control Parameter

The Control parameter activates certain Fixture, Shutter, and Lamp functions on other Channels.
To access all control settings in Standard Protocol (except for Pan & Tilt MSpeed Off), first select
a control channel value, then set the Shutter channel to "0."

Studio Command 1200/700

Control Setting
Safe
Pan & Tilt
MSpeed Off
Display Off
Display Dim
Display Bright
Home
Lamp On
Lamp Off
Shutdown
Lamp Assisted
Strobes
Lamp functions
Lamp/mechanical
dimming
Lamp only dimming

Studio Command H

Control Setting
Disables all Control settings for normal operation. The
Safe
Control channel should not be crossfaded.
Pan & Tilt Sets Pan & Tilt MSpeed to off. The Control channel
MSpeed Off should not be crossfaded.
Display Off Sets display to off.
Display Dim Dims display characters.
Display Bright Brightens the display characters.
Home Remotely homes the fixture.
Remotely deactivates the fixture. When a fixture is shut
down, the lamp is extinguished, power to the motors is
Shutdown disabled, and the LED display reads "SHUT DOWN". If
a fixture is in shutdown mode, you must home the
fixture to bring it back into operation.
Studio Command Series User Manual
Description
Disables all Control settings for normal operation.
The Control channel should not be crossfaded.
Sets Pan & Tilt MSpeed to off. The Control channel
should not be crossfaded.
Sets display to off.
Dims display characters.
Brightens the display characters.
Remotely homes the fixture.
Remotely restrikes the fixture's lamp.
Remotely extinguishes the fixture's lamp.
Remotely deactivates the fixture. When a fixture is
shut down, the lamp is extinguished, power to the
motors is disabled, and the LED display reads "SHUT
DOWN". If a fixture is in shutdown mode, you must
home the fixture to bring it back into operation.
Periodic and Random strobe functions are lamp
assisted. Ramp functions are not lamp assisted.
Modifies the shutter channel
Lamp output will vary from a minimum to 1200/700
Watts as the mechanical dimming ranges from 0–
100%
Electronic dimming only from a minimum to 1200/700
Watts.
Description
CHAPTER 4
Fixture Programming
Notes
Command is sent
instantaneously
Commands must be sent
for 20 consecutive DMX
packets (1.25 seconds).
Commands must be sent
for 5 seconds.
The shutter does not have
to be set to 0 for Lamp
functions
Notes
Command is sent
instantaneously
Commands must be sent for
1.25 seconds.
Commands must be sent for
5 seconds.
53