Setting Up A Dmx Link - High End Systems Studio Command Series User Manual

Setting Up a DMX Link

To link one or more fixtures to a controller using
either 3-pin or 5-pin XLR cables:
1. Connect the male XLR connector of a DMX
Data cable to the controller's DMX Data Out
connector.
2. Connect the Data cable's female XLR
connector to the Data In connector of the first
(or next) fixture on the DMX link.
3. Continue linking the remaining fixtures
connecting a cable from the Data Out
connector of each fixture to the Data In
connector of the next fixture on the link.
4. Connect a male terminator to the Data Out
connector of the last fixture in the link. For
information on obtaining a terminator, see
Related Products and Accessories on page 4.
DMX
Console
Studio Command Series User Manual
Connecting to a DMX link using 5-pin connectors
3-pin Data Out
3-pin Data In
Data cable connectors on
he Studio Command
Data cable connectors on
the Studio Command
CHAPTER 2
Setup and Configuration
5-pin Data In
5-pin Data Out
®
1200/700 fixture pane
5-pin Data In
5-pin Data Out
®
H fixture panel
Termination
Resistor
15