Replacing The Lamp - High End Systems Studio Command Series User Manual

CHAPTER 5
General Maintenance
Note: If you are replacing the fuses on the LED display panel or the filter panel,
you must first remove the protective plastic covering over the fuse(s).
If applicable, reinstall the protective plastic covering over the fuse.
11. If you removed the motor power supply board assembly, replace the assembly in the fixture
and reinstall the three screws.
12. Reconnect the Ground, L1, and L2 wires to the motor power supply board.
13. Reconnect the motor power supply cable to the logic board.
14. Return the filter panel and/or the LED display panel to the original, upright position and
tighten the display panel retaining screws.
15. Replace the two panel covers and tighten the four panel cover retaining screws.

Replacing the Lamp

Warnings:Disconnect power before re-lamping or servicing.
Caution: This equipment is designed for use with specified. Use of any
You will need:
• appropriate lamp for your Studio Command Model
(see Lamp Specifications on page 7),
• protective gloves and eyewear
• wide tip, flat head screwdriver
To replace the lamp:
1. Disconnect power to fixture.
If the fixture has been operating, wait for the
lamp to cool before handling.
2. Put on protective eyewear and gloves.
58
An operating, unshielded MSR lamp emits ultraviolet and
visible (UV-vis) radiation which could damage eyes and skin.
Whenever you are working on or near an exposed lamp, wear
protective eye gear. Never look directly at the lamp while the
lamp is on.
Hot lamp may be an explosion hazard. Do not open for five
minutes after switching off. Wear eye and hand protection
when re-lamping.
Equipment surfaces may reach temperatures up to 160° C
(320° F). Allow the fixture to cool before handling.
other type lamp may be hazardous and may void the
warranty.
A
Lamp cap and assembly screws.
Studio Command Series User Manual
B