Table of Contents
Advertisement
www.weg.net
Web Server Port:
It is a number used to access the Web interface of RS485-ETH-N. Default value is 80. In order not to experience
any problems in routing, it is recommended not to have another device connected to the network listening to the
selected port. When a port number other than the default value is used, write ";" and then the selected port number
in the address line of the Web browser, after the IP address in order to access the Web interface.
Example: If IP address of RS485-ETH-N is assigned as 192.168.35.27 and network server port as 601, the address
192.168.35.27:601 must be written in the address area of the Web browser in order to access Web interface.
Ping:
Ping command is a general command that queries the existence of a device in a particular IP address in a network.
By this command, it is also possible to check whether RS485-ETH-N is connected to the network properly. If
this option is enabled, RS485-ETH-N responds to the ping query, if it is not, RS485-ETH-N does not respond to
the ping query.
3.3 SERIAL PORT SETTINGS
In this tab, serial communication settings of RS485-ETH-N are made. Values in this tab should be selected in
accordance with the devices with serial interfaces in the MODBUS network. If these values are not set in accordance
with the MODBUS network, a healthy serial communication will not be performed. Default serial communication
settings for RS485-ETH-N are as follows:
Baud Rate
38400
Stop Bit
1
Parity
None
Tabela 3.2: Default Serial Port Settings for RS485-ETH-N
Baud Rate:
RS485-ETH-N supports 300, 600, 1200, 2400, 4800, 9600, 19200, 38400, 57600 and 115200 baud
rates.
Stop Bit:
RS485-ETH-N supports 1 and 2 stop bit.
Parity:
RS485-ETH-N supports single parity and double parity modes and modes without parity.
Figura 3.5: Serial Port Settings
16 | Ethernet / Serial Gateway - RS485-ETH-N
Advertisement
Table of Contents
