Table of Contents
Advertisement
www.weg.net
USB Port:
Micro-USB cable must be inserted to this port. Device can power on with USB port as well. If
operator wants to use WEG GATEWAY MASTER must be connected to PC over micro-usb cable.
RS485 Port:
It provides to communicate with the devices that support Modbus Protocol.
2.2 CONFIGURING RS485-ETH-N
There are three options when RS485-ETH-N is configured.
1. Using WEG GATEWAY MASTER software over USB port. (Will be explained in "Section 3").
Figura 2.2: Gateway Master Software
2. Writing RS485-ETH-N IP address to the WEG GATEWAY MASTER. (Will be explained in "Section 4").
Figura 2.3: Connect via ethernet with Gateway Master
Ethernet / Serial Gateway - RS485-ETH-N | 9
Advertisement
Table of Contents
