Web Interface / Connection Via Ethernet - WEG RS485-ETH-N User Manual

Ethernet/serial gateway
Table of Contents

Advertisement

www.weg.net

4 WEB INTERFACE / CONNECTION VIA ETHERNET

RS485-ETH-N Web interface is a software in which all the configuration settings of RS485-ETH-N series products
can be made and which can run over embedded Web server. To access the Web interface, any device with an
installed Web browser, including tablet and smart phones can be used.
Home page of the Web interface can be accessed by writing RS485-ETH-N default IP address 192.168.35.15 on
the address line of the Web browser or by writing the assigned IP address using configuration software. Default
password is "Pass". For the reason that RS485-ETH-N is a device that can be accessed from the Internet, it is
important to change the default password for security. Steps for changing the password will be explained in detail
below.
Figura 4.1: Web Interface Home Page
If the password is entered correctly, configuration tabs will appear on the screen.
Figura 4.2: Web Interface Network Settings Tab
Except security settings, Web interface is very similar to the configuration software from the design point of view.
Therefore tabs except the "Security Settings" tab are not covered in detail here.
Ethernet / Serial Gateway - RS485-ETH-N | 25

Advertisement

Table of Contents
loading

Table of Contents