www.weg.net
3 CONFIGURATION SOFTWARE
After the steps in "Section 2" are completed successfully:
RS485-ETH-N must be connected to the PC via Micro-USB cable;
After that configuration software must be run. Configuration software can be accessed by the shortcut
created from the Windows Start menu or by the shortcut created on the desktop;
3.1 CONNECTION SETTINGS
If RS485-ETH-N is connected to the PC via USB cable, virtual COM port to which RS485-ETH-N connects will
be listed in the software as in Figure 3-2. If the correct port doesn't appear on the list, the list can be updated by
clicking the "Refresh" button.
Figura 3.1: Virtual Com Port that RS485-ETH-N is connected
NOTE: If the virtual serial port to which RS485-ETH-N connects is not known, it can be selected as
shown in Figure 3-2. After the correct port is selected, software connection to RS485-ETH-N is ensured
by pressing "Connect" button.
Ethernet / Serial Gateway - RS485-ETH-N | 13