Table of Contents
Advertisement
www.weg.net
3. Writing RS485-ETH-N IP address to the Web browser. (Will be explained in "Section 4").
Figura 2.4: RS485-ETH-N Web interface
NOTE: In order to access RS485-ETH-N web interface; operator should change RS485-ETH-N default IP and
other related settings with using WEG GATEWAY MASTER software.
2.3 REQUIRED INSTALLATIONS FOR CONFIGURATION SOFTWARE
In order to configure RS485-ETH-N over USB port, required installations will be explained in this section.
Operator can find necessary files in the CD that is in product box.
„ Setup=>WEG GATEWAY MASTER.exe must be installed for RS485-ETH-N configuration software.
2.3.1 Installing RS485-ETH-N Configuration Software
Run WEG GATEWAY MASTER.exe which resides in the CD that comes with the product.
After selecting the desired target where software will be setup, click on the "Next" button and continue with the
next step.
Figura 2.5: Weg Gateway Master-first step
10 | Ethernet / Serial Gateway - RS485-ETH-N
Advertisement
Table of Contents
