Rs-485 Connector; Network Settings; Number Of Monitored Assets; Internet Connection Requirements - WEG Drive Scan Manual

DRIVE SCAN COMMUNICATION

4.3 RS-485 CONNECTOR

4.4 NETWORK SETTINGS

4
All the devices connected to physical networks, whether via RS-485 or Ethernet, must have the same baud rate,
data bit, parity and stop bit settings, so that the respective network works correctly.

4.5 NUMBER OF MONITORED ASSETS

4.6 INTERNET CONNECTION REQUIREMENTS

For the proper operation of the Drive Scan and connection to the MFM cloud, the customer's network must meet
some requirements and have some releases.
Note: to release the addresses, ports and internet access, ask the IT team in charge of the network.
The user's network must not have VPN or PROXY;
The ports of Table 4.3
broker.app.wnology.io
hub.docker.com
nexus3.weg.net
Medium Voltage Devices | 4-2
Table 4.2: Signals of the WCD-ED300 Drive Scan RS-485 Connector
Pino
1
2
3
4
5
6
and the IP addresses of
Table 4.3: Addresses required for the Drive Scan communication with the MFM
Destino
Table 4.4: Ports required for the Drive Scan communication with the MFM
Protocolo
TCP
TCP
TCP
TCP
Sinal
Negative RS-485
GND
Positive RS-485
Positive RS-485
GND
Negative RS-485
Table 4.4 must be accessible.
IP
146.0.0.0/8
3.225.66.59
Dynamic address
Porta
80
Update/Support the Drive Scan
433
and Send data to the MFM
1883
8883
Objective
Send data to the MFM
Edge-Agent Maintenance
Firmware update
Objetivo