Table of Contents
Advertisement
www.weg.net
Figura 3.2: COM Port Selection
NOTE: After the connection, "Device Information", "Serial Configuration", "Network Settings", "Gateway
Configuration", "About", "Disconnect", "Read" and "Write" tabs will be enabled and they will be visible on the
tabs concerning up-to-date configuration settings of the connected RS485-ETH-N. RS485-ETH-N must not be
disconnected from the USB without clicking the "Disconnect" button. "Security Configuration" will be enabled
when connected via ethernet.
3.2 NETWORK SETTINGS
In this tab, settings for the network to which RS485-ETH-N connects are made. Meanings of the
terms used in this tab are briefly as follows:
Figura 3.3: Network Settings
14 | Ethernet / Serial Gateway - RS485-ETH-N
Advertisement
Table of Contents
