Configuration The Sensors - WEG Cassia X1000 Installation And Operation Manual

7 CONFIGURATION THE SENSORS

After installing the gateway in the field, you should check which sensors are in range. This activity is performed
using the gateway screen in WEG Motion Fleet Management (https://mfm.wnology.io).
Using the WEG Motor Scan application, enable the "gateway mode" of the sensors listed on the screen in WEG
Motion Fleet Management.
1. On the app home
screen, press one of the
sensors close to you.
2. Pair the sensor and
wait until the "Panel"
screen with the latest
measurements made
by WEG Motor Scan
appears.
3. Press "More" to
access the sensor
settings.
4. On the "More" tab,
press "Turn on
gateway mode".
5. Press "YES" and wait
for the synchronization
with the sensor.
After finishing the procedures, the sensor will be able to send its data to the gateway.
Downloading data using a smartphone is still possible; however, with a slight loss of pairing performance (not
affecting the download performance).
For the sensor firmware upgrades, reset, or motor nameplate data editing, you must disable the "Gateway mode"
by undoing the last step of this procedure.
1
4
Configuration the Sensors
2
5
Gateway Cassia X1000 | 21
3