Biddle Comfort Circle Series Manual page 24

I
NSTALLATION
2
3
24
2.13.2 Mounting and connecting the controller
1. Lay the control cable.
2. If the external-control input in the controller is used (see
3. Open the controller 1.
1
4. Lead the control cable and the external control cable (if
5. Screw the back plate onto the socket or the wall.
6. Lead the cable/s through the pull reliefs.
4
5
7. Couple the connector to the PCB 4.
8. Connect the external-control cable (if any) to the terminal
9. Put the front onto the back plate.
2.13.3 Connecting the controller to the unit
1
The controller sockets 1 and 2 are located in the connec-
2
tor plate on the front side of the unit. The two sockets are
identical.
1. Connect the control cable to the free socket 1 or 2.
Multiple units operated from one controller
1. Interlink the units: connect the control cables to 1 and 2.
section 2.15.2):
Lay the necessary cabling. The cable core diameter is not
to exceed 0.75 mm² AWG 20.
any) through the back plate.
- The upper left pull relief 2 is designed for the control
cable, and the upper right pull relief 3 for the external-
control cable.
- The cable must protrude some 9cm from the pull relief.
on the PCB 5.
C C
OMFORT IRCLE