Connecting The Condensate Discharge (Cc C) - Biddle Comfort Circle Series Manual

M
ANUAL
2.7

Connecting the condensate discharge (CC C)

1
3
Version: 1.0 (22-09-2005)
Connecting CH and CW separately
1. Connect the CH signal cable to output O1 1.
2. Connect the cold water machine signal cable to
2
1
3. Set function 91 (output O1 function) to value 55 (heating
4. Set function 91.5 to value 0 (make contact ).
5. Set function 92 (output O2 function) to value 56 (cooling
6. Set function 92.5 to value 0 (make contact ).
Connecting CH and CW together
1. Connect the signal cable of the change-over system to out-
2. Set function 91 (output O1 function) to value 57.
1
3. Set function 91.5 to value 0 (make contact ).
The units with cooling come standard with a condensate
draining pump. The condensate is drained from the unit
>2%
through a flexible hose.
1. Install a sewer connection incl. stink trap for the discharge
2. Connect the discharge hose 1 to the drain pipe.
3. Mount the external drip tray 2 using the supplied
3
2
output O2 2.
demand).
demand).
put O1 1.
If the unit switches from heating mode to cooling mode, a
signal is sent to the output.
of condensate.
In doing so, pay attention to this:
- For proper condensate discharge, the drain pipe must
be sloping (>2%).
- Avoid kinks in the discharge hose.
- Above the ceiling, the discharge hose must be insulated.
screws 3.
I
NSTALLATION
17