Parts And Functions (Dc Inverter) - Haier Super Match Series Service Manual

Parts and Functions
Indoor Unit
Vertical blade
(adjust left and
right airflow,inside)
Outlet
Inlet grille
Vertical blade
Please be subject to the actual produce purchased the
above picture is just from your reference
POWER TIMER
EMERGENCY SWITCH
EMERGENCY
ON/OFF button
SWITCH
Push once to start operation,push once again
to stop it.
Operation is set to AUTO,air flow is set to
AUTO fan.
Use when remote controller is not available.
Upon receiving a signal, there is a receiving
Signal Receiver
sound.
Outdoor Unit
OUTLET
CONNECTING PIPING AND ELECTRICAL WIRING
4
DRAIN HOSE
INLET
Please be subject to the actual produce purchased the
above picture is just from your reference
Horizontal flap
(adjust up and down airflow
Don't adjust it manually)
indicator light
Emergency
Switch
Air Purifying Filter
(inside)
Outlet
RUN
EMERGENCY AND TEST
SWITCH
Signal Receiver
4
Remote controller
1
2
3
4
5
9
10
11
12
13
14
15
16
17
1. Mode display
Operation mode
AUTO COOL DRY HEAT
Remote controller
2. Signal sending display
3. SWING display
4. FAN SPEED display
Display
circulated
AUTO
LO MED HI
5. LOCK display
6. TIMER OFF display
TIMER ON display
7.TEMP display
Healthy function is not available for some units.
Loading of the battery
2
3
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
type fluorescent lamp or wireless telephone is installed in the
room, the receiver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batteries have been used up. Please change batteries.
If the remote controller can't run normally during operation,please
remove the batteries and reload several minutes later.
Hint:
Remove the batteries in case won't be in use for a long period. If
there is any display after taking-out, just press reset key.
247
System configuration
8. Additional functions display
6
Supplemented
Operation mode
QUITE SLEEP electrical
heating
Remote controller
7
9. QUIET button
10. HEAT button
11. COOL button
12. AUTO button
8
13. FAN button
14. TIMER button
18
15. HEALTH button
16. LOCK button
19
Used to lock buttons and LCD display.
20 17. LIGHT button
Control the lightening and extinguishing
of the indoor LED display board.
21
18. POWER ON/OFF button
19. DRY button
22
20. TEMP button
21. SWING button
23
22. HOUR button
24
23. EXTRA FUNCTION button
Function: Air sending--- Healthy
25
airflow position1--- Healthy airflow
position 2 --- Restore the original flap
position --- Right & left air airflow---
A-B yard--- 10 and heating symbol
FAN
displayed simultaneously--- Sleeping---
Electrical heating--- Refresh air(
--- Power--- Fahrenheit/Celsius
function)
mode conversion
24.CANCEL/CONFIRM button
Function: Setting and cancel to the
timer and other additional functions.
25. RESET button
When the remote controller
appears abnormal, use a sharp
pointed article to press this button
to reset the remote
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
1
3
Be sure that the loading
" + "/"-";
is in line with the
Domestic air conditioner
HEALTH POWER
reserved