Haier Super Match Series Service Manual page 410

Operation
Timer On/Off On-Off Operation
1.After unit starts, select your desired operation mode.
TIME
TIME
2.Press / button to change TIMER mode.
ON
OFF
TIME
ON
Press button " 0.5 " will appear ,after 10 seconds
ON
the time display will be blank.
TIME OFF
Press button " 0.5 " will appear ,after 10 seconds
OFF
the time display will be blank.
Then select your desired TIMER mode (TIMER ON or
TIMER OFF ). " "or "
TIME
3.Press / TIME button to set time.
ON
OFF
Press the button for each time, setting time in the first
12 hours increased by 0.5 hour every time, after 12
hours,increased by 1 hour every time.
4.Confirm timer setting
After adjust the time,press
time ON or OFF button will not flash any more.
5.Cancel timer setting
Press the button the time display eliminated.
Hints:
After replacing batteries or a power failure happens, time
setting should be reset.
According to the Time setting sequence of TIMER ON or
TIMER OFF, either Start-Stop or Stop-Start can be
achieved.
HEALTH Operation
(This function is unavailable on some models.)
Press HEALTH button , the remote controller will show
and then achieve to the health function.
Press again this HEALTH button , the health function will be
cancelled.
The anion generator in the airconditioner can generate
a lot of anion effectively balance the quantity of position
and anion in the air and also to kill bacteria and speed
up the dust sediment in the room and finally clean the
air in the room.
"will flash.
button and confirm the
TURBO Operation
(This function is unavailable on some models.)
Turbo/Quiet Auto
2 Cool Heat
When you need fast cool or fast dehumidification,you
can choose the Turob function; when you sleep, read,
you can choose Quiet function
Press the bu on, you can switch the "Turbo"
Turbo/Quiet
and "Quiet"
will swith as below
（TURBO）
When running in Turbo，the fan speed is the highest,
when running in Quiet, the fan speed is super slow
Loading of the battery
4
Load the battery,then put on the cover again.
Note:
The distance between the signal transmission head and the rece-
iver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change- over
type fluorescent lamp or wireless telephone is installed in the
room, the recei ver is apt to be disturbed in receiving the signals,
so the distance to the indoor unit should be shorter.
Full display or unclear display during operation indicates the
batte ries have been used up. Please change batteries.
If the remote controller can't run normally during operation, please
remove the batteries and
409
System configuration
Dry
cancel
（QUIET）
1
Remove the battery cover;
2
Load the batteries as illustrated.
2 R-03 batteries, resetting key
(cylinder);
3
Be sure that the loading
e" + "/"-";
is in line with th
reload several minutes later.
Domestic air conditioner