Technical Specification - Graco SDM8 Series Instructions Manual

Technical Specifications
Technical Specifications
SDM8 and SDM18 Metered Dispense Valve
Flow range*
*Tested in 10W motor oil. Flow rates vary with fluid pressure, temperature and viscosity.
Maximum Working Pressure
Units of Measure (factory set to
quarts)
Weight
Dimensions (without extension)
Length
Width
Height
Units of measure (factory set in
quarts)
Inlet
Outlet
Operating temperature range
Storage temperature range
Battery**
**Recommended battery: Energizer
Wetted parts
Fluid compatibility
Metered Dispense Valve Accuracy†
† At 2.5 gpm (9.5 lpm), at 70°F (21°C), with 10-weight oil and 1 gallon dispensed. May require calibra-
tion.
California Proposition 65
WARNING: This product can expose you to chemicals known to the State of California
to cause cancer and birth defects or other reproductive harm. For more information, go to
www.P65warnings.ca.gov.
30
US
0.25 to 18 gpm
pints, quarts, gallons
maximum recorded dispensed volume = 9999 units
4 °F to 158°F
-40°F to 158°F
®
Alkaline E91.
aluminum, stainless steel, PBT, nitrile rubber, zinc plated carbon
antifreeze, gear oil, crankcase oil, ATF, windshield washer fluid
1500 psi
5.3 lb
13 in.
3.75 in.
5.75 in.
1/2-14 npt or 3/4-14 npt
1/2 BSPP/BSPT or 3/4BSPP/BSPT
3/4-16 straight thread o-ring boss
4AA alkaline batteries
steel, nickel plated carbon steel
(up to 50% alcohol-based solutions)
Metric
0.9 to 68 lpm
103.4 bar
liters
2.4 kg
33 cm
9.5 cm
14.6 cm
-16°C to 70°C
-40°C to 70°C
+/- 0.5 percent
3A6711C