Installation
Install the Nozzle
1.
Thread nozzle (3) onto extension (2)
(F
. 9).
IG
F
. 9
IG
2.
With an open-end adjustable wrench on
the flats of the nozzle bushing, tighten
firmly (F
. 10).
IG
F
. 10
IG
12
•
•
2
3.
3
4.
5.
NOTICE
To prevent damaging nozzle, only
tighten nozzle with wrench on flats of
the nozzle bushing as shown in F
10.
Do not disassemble the bushing
from the nozzle. Disassembly will
affect the performance of the nozzle.
Open the automatic twist lock nozzle and
all fluid shut-off valves. Start pump to
pressurize system.
To ensure dispensing accuracy, purge all
air from the fluid lines and metered
dispense valve before you use it.
Set the system flow to the desired flow
rate. This is typically done by adjusting
the pump air pressure.
.
IG
3A6711C