Service And Maintenance - Culligan Premier Series Installation, Operation And Service Instructions

Deionizer Information
SERVICE
FEB-01-13 12:11P
10.0GPM 161PPM
>1)INFORMATION
2)MANUAL REGEN
3)SET DATE/TIME
4)ADV. SETUP
CURRENT FLOWRATE
0.0
GPM
REMAINING CAP
100000 Gals
100%
DAYS SINCE LAST
REGEN
1: 1 DAYS
TOTAL GALLONS
SINCE NEW
1: 0 GALS
WATER QUALITY
OK
FWR***LT30
MON DD YEAR
S/N:00001982
SERVICE
FEB-01-13 12:11P
10.0GPM 161PPM
Cat. No. 01024000
1. From the default home screen, press
2. Press . The screen displays the deionizer information beginning with the current
flow rate.
3. The controller monitors the flow rate for the deionizer tank. If the system uses two
tanks, the screen displays the flow rate for each tank.
4. Press or to display the next setting,
5. The screen displays the gallons deionized since the most recent system regener-
ation. Press and
setting.
6. The screen displays the days elapsed since the most recent system regeneration.
Press and to display the next setting. Press
7. The screen displays the total gallons that have flowed through the system since
the system was installed. Press
see the previous setting.
8. The screen displays the water quality of the deionizer tank(s). The screen displays
OK or NOT OK when using an external quality probe. The screen displays the
measured TDS when using an interior TDS probe. Press
next setting. Press
9. The screen displays the firmware version, born-on date of the firmware version,
and serial number of the deionizer controller. Press
main menu. Press
10. Press until the deionizer controller displays the home screen.

Service and Maintenance

to display the main menu.
to display the next setting. Press
and to display the next setting. Press
to see the previous setting.
to see the previous setting.
to see the previous
to see the previous setting.
to
and to display the
and to return to the
Service and Maintenance 41