Installation; Ambient Conditions - Thermo Scientific STANDARD Series Manual

Ambient
Conditions
CAUTION
CAUTION
CAUTION
Thermo Scientific

Installation

Section 3
Ambient Temperature Range
Maximum Relative Humidity
Operating Altitude
Overvoltage Category
Pollution Degree
Degree of Protection
The unit is designed for continuous operation and for indoor use.
The thermostat normally ships with it mounted facing the reservoir. You may
change the position ±90° by removing thumb screws, no tools are required.
Do not mount it backwards; the line cord could contact the reservoir
fluid.

Rotate thermostat
only ±90° from shown
position
The nozzle at the end of the pump can be repositioned for maximum flow
in the bath. When repositioning the head ensure the nozzle is not directed
towards a bath wall. There is a second opening on the pump that is capped,
remove the cap if that direction is needed.
Never place the unit in a location where excessive heat, moisture,
inadequate ventilation, or corrosive materials are present.
Refrigerated units should be left in an upright position for 24 hours
before starting. This will ensure the lubrication oil has drained back
into the compressor.
5°C to 40°C (41°F to 104°F)
80% at 31°C (88°F)
Sea Level to 2000 meters (6560 feet)
II
2
IP 20


3-1