Thermo Scientific STANDARD Series Manual page 16

Section 3 Installation
3-4
For refrigerated baths:
Ensure all communication and electrical connections are made prior to
starting the unit.
• Install the power cord from the connector on the rear of the
controller, A, to the connector on the rear of the refrigerated bath, B.
• Connect the bath's power cord, C, to a grounded power outlet.
B = Power Outlet to Thermostat
C = Power Inlet
For refrigerated baths, never connect controller power inlet, A, to
a power outlet. Never connect power outlet, B, to anything but a
thermostat.

Ensure the electrical cords do not come in contact with any of the
plumbing connections or tubing.
• Install the supplied communications cable between the thermostat
and the bath RJ45 connectors (similar to Ethernet).
Communication
Cable required for
proper communication
between the bath and the
thermostat.
Communication


Thermostat
A = Power Inlet from Bath
Bath
Power Supply
Thermostat
Bath
Thermo Scientific