Stowing The Track; Removing Track When Chair Is Occupied; Figure 20 - Using Handle To Deploy Track; Figure 21 - Track Stowed - Ferno Compact 2 Track Chair User Manual

Table of Contents

Operating the Chair

4.5 Stowing the Track

When not in use always ensure the Track is folded away

securely to limit the chance of damage or injury.

1. To fold the track into the back of the chair, push the bar

with RED 'Push to Close' label downwards as shown, until

the track is flush with the back of the chair and locks into

position. When in the stowed position the track should

remain in the upright position and should not drop back

down. If the track bracket mechanism is found to be loose

and the track not staying upright then the chair should be

taken out of service and the holding gas strut replaced.

Figure 20 - Using 'Push to Close' bar to stow Track

4.6 Removing the Track - Method 1

Prior to folding the chair for storage or using chair as a

carry chair, the Track must be removed. When the Chair is

occupied with a patient, it is recommended to remove the

track using the following procedure:

1. Pull the RED Track release bar down towards the floor

to release the locating pins from the two push-to-close

latches and detach Track from the top of the Chair.

Figure 22 - Releasing Track from push-to-close latches

2. With the Track at an angle to the Chair pull the spring

loaded handle away from the axle to unlock, then pull the

Track away from the Chair.

Figure 23 - Releasing the Track from the Chair

Compact 2 Track Chair

Table of Contents