Removing The Track When Chair Is Not Occupied; Adjusting Upper Handle Height; Figure 24 - Removing Track From Unoccupied Chair; Figure 25 - Chair Height Adjustment Index Pin - Ferno Compact 2 Track Chair User Manual

Compact 2 Track Chair
4.7 Removing the Track - Method 2
When the Chair is not occupied with a patient, the track
should be removed using the following procedure:
1. As before, pull the RED Track release bar down to release
the Track locating pins from the push-to-close latches (fig
22)
Figure 24 - Removing the Track from an unoccupied
2. Then with the Track laid on the ground, pull back the RED
release handle on the Track with your heel, and then lift the
Chair out of the Lock.
WARNING
Only fully raise the handle when using the Chair to
descend stairs with the Track deployed.
© Ferno (UK) Ltd. FERNO/MAN/R5/08/18/207/UK
Chair

4.8 Adjusting Upper Handle Height

The upper handle can be adjusted to different positions for
when used as a Track Chair and when used as a Carry Chair.
1. To adjust the handle, pull the index pin out and pull the
handle until the first position is reached then release the
index pin.

Figure 25 - Chair height adjustment index pin

2. When using as a Track Chair the Rear handle should be
raised to the highest position. Position 4 below.
Figure 26 - Adjustable handle heights
3. When using as a carry Chair the upper handle can be
adjust to optimize posture of operators. Position 1, 2 & 3
above.
It is NOT recommended to use position 4 when using as a
Carry Chair.
Operating the Chair
13