Related Manuals for Ferno 23
Summary of Contents for Ferno 23
- Page 1 Users’ Manual Model 23 Roll-In Style Mortuary Cot Read this Manual and Retain for November 2007 GLO Future Reference Pub. No. 234-0059-05...
-
Page 2: Ferno Customer Relations
Limited Warranty Statement Retain this manual for future reference. Include it with the The products sold by Ferno are covered by a limited warranty, product in the event of transfer to new users. Additional free which is printed on the invoice you received when you copies are available upon request from Customer Relations. -
Page 3: Table Of Contents
4.2 General Guidelines for Use ......... 8 7.3 Attaching the Foot Stop ........14 4.3 Changing Cot Positions ........8, 9 Training Record ............. 15 4.4 Transferring the Body Onto the Cot ....9 Maintenance Record ............. 15 © Ferno-Washington, Inc. 234-0059-05 November 2007... -
Page 4: Safety Information
The symbols defined below are used on the cot and in this Improper operation can cause injury. Operate users’ manual. Ferno uses symbols recognized by the the cot only as described in this manual. International Standards Organization (ISO), American National Standards Institute (ANSI) and the mortuary An unrestrained body can fall off the cot. -
Page 5: Operator Skills And Training
• Two 5-inch swivel transport wheels (operator end) Relations (page 2) or your Ferno distributor. • Two 5-inch fixed transport wheels (loading end) Ferno reserves the right to change specifications without notice. • Leg-protecting scuff blocks • Sidearms (optional) LOAD LIMIT... -
Page 6: Components
To raise a sidearm, rotate the sidearm upward until the pin locks into place. Important Sidearms are not designed for lifting. Use only the main frame to lift the cot. Figure 1 - Using the Swing-Down Sidearm © Ferno-Washington, Inc. 234-0059-05 November 2007... -
Page 7: Restraints
Important to Engage the Leg Lock Do not engage the leg lock while the cot is loaded in a vehicle. Verify that the leg lock is disengaged before unloading the cot from the vehicle. © Ferno-Washington, Inc. 234-0059-05 November 2007... -
Page 8: Using The Cot
Set up the cot, following the instructions in Cot Setup, page 14. Confirm that the cot operates properly. See Inspecting the Cot (page 12). The vehicle transporting the cot must have a Ferno cot fastener system installed. Read Users’ Manual Cot May be Operated... -
Page 9: Transferring The Body Onto The Cot
4.4 Transferring the Body Onto the Cot Important Ferno recommends that you position the body with the head at the operator Position the body with the head at end of the cot, if possible. This orientation will place the body in a “heads the operator end of the cot if up”... -
Page 10: Loading The Cot Into A Vehicle
4. When the cot is completely inside the vehicle, release the control handle and set the cot on its loading posts. Figure 8 - Loading and Unloading the Cot 5. Secure the cot in the vehicle with an approved Ferno cot fastener. 4.7 Unloading the Cot... -
Page 11: Maintenance
When using maintenance products, follow the manufacturers’ directions and read the manufacturers’ material safety data Minimum sheets. You can purchase a recommended disinfectant from Maintenance Intervals your Ferno distributor or Ferno Customer Relations (page 2). • Disinfecting (this page) 5.2 Disinfecting and Cleaning •... -
Page 12: Inspecting The Cot
2 ..Leg control mechanism pivot points ......4 in all 3 ..Leg lock bar ..............2 slots LUBRICATION-FREE ITEMS Leg tees (plastic bushings) ....... Do not lubricate Loading wheel bearings ......Do not lubricate Transport wheels (sealed bearings) ..Do not lubricate © Ferno-Washington, Inc. 234-0059-05 November 2007... -
Page 13: Parts And Service
Modifying the cot can cause injury and damage. Use the cot only as designed by Ferno. 6.2 Worldwide To order Ferno parts and for professional repair, contact your Ferno distributor. Your distributor is the only agent authorized by Ferno to manage, service, and repair Ferno products. -
Page 14: Cot Setup
WARNING and Accessories Attaching improper items to the cot can cause injury. Use only Ferno-approved items on the cot. Before placing the cot in service, assign appropriate personnel to install the mattress, restraints, and any accessories shipped with the cot. -
Page 15: Training Record
Model 23 Cot TRAINING RECORD Date Training Method Name MAINTENANCE RECORD Date Maintenance Performed © Ferno-Washington, Inc. 234-0059-05 November 2007...