Simrad NSO evo3S MPU Operator's Manual page 39

The edit track dialog can also be accessed by selecting the waypoints tool on the home
page.
Dock-to-dock Autorouting and Easy Routing
The Dock-to-dock Autorouting and Easy Routing suggest new routepoint positions based on
information in the map and on your boat's size. Before you can start using this feature the
boat draught, width and height must be entered into the system. The boat settings dialog is
automatically displayed if the information is missing when you start the feature. To enter
boat settings, refer to "System settings" on page 135.
Ú Note:
It is not possible to start the Dock-to-dock Autorouting or Easy Routing if one of
the selected routepoints is located in an unsafe area. A warning dialog is displayed, and
you have to move the relevant routepoint(s) to a safe area to proceed.
Ú Note:
If no compatible cartography is available, the Dock-to-dock Autorouting or Easy
Routing menu option is not available. Compatible cartography includes C-MAP MAX-N+,
Navionics+ and Navionics Platinum. For a full selection of available charts, visit
www.gofreemarine.com, www.c-map.com or www.navionics.com.
1.
Position at least two routepoints on a new route, or open an existing route for editing.
2.
Select the Dock-to-dock Autorouting menu option, followed by:
- Entire Route - if you want the system to add new routepoints between the first and the
last routepoint of the open route.
- Selection - if you want to manually select the routepoints that define the limits for the
autorouting, then select the relevant routepoints. Selected routepoints are colored red.
Only two routepoints can be selected, and the system discards any routepoints
between your selected start and end points.
3.
Select the accept option to start the automatic routing.
- When the automatic routing is completed the route appears in preview mode, and the
legs are color coded to indicate safe or unsafe areas. Navionics uses red (unsafe) and
green (safe), while C-MAP uses red (unsafe), yellow (dangerous) and green (safe).
4.
Move any routepoints if required when the route is in preview mode.
5.
Select the keep option to accept the routepoints positions.
6.
Eventually repeat step 2 (selection) and step 3 if you want the system to automatically
position routepoints for other parts of the route.
7.
Select the save option to complete the automatic routing and save the route.
Dock-to-dock Autorouting and Easy Routing examples
Entire route option used when first and last route points are selected.
•
First and last routepoint
Selection option used for autorouting part of a route.
•
Two routepoints selected
Waypoints, routes, and tracks | NSO evo3S MPU Operator Manual
Result after automatic routing
Result after automatic routing
39